Beamline Instrument Software Support |
|
SPEC Macro documentation:
[ Macro Index |
BCU Home ]
|
Conductuscurves.mac | ||||||
[ source code | installed at | configured at ] | ||||||
See other macros in category: All | ||||||
Description:
| ||||||
Documentation:
Each Conductus temperature controller is delivered with his own sensors. ID18 wish to be able to use all sensors with all temperature controllers they have. Thus the calibration curves have to be loaded into the controller. | ||||||
Macros:
Usage: condcurves_debug toggle debug mode for the present macros. condgpib_setup Usage: condgpib_setup Syntax : condgpib_setup <GPIB unit> <GPIB number>. Set the global COND_ADDR which is used for all gpib access. condlistallcurves Usage: condlistallcurves Syntax : condlistallcurves List out all the curves used in the controller. There are 16 possible curves. condlistonecurve Usage: condlistonecurve Syntax : condlistonecurve indexnumber List out the requested curve from the controller. There are 16 possible curves. condwritecurve Usage: condwritecurve Syntax : condwritecurve [filename] Reads one sensor calibration curve from harddisk and writes it into the Conductus temperature controller. Only curves 10 to 26 can be written. EXAMPLE: Sensor Type: 0 = 2V Diode, 1 = 6V Diode, 2 = R250, 3 = R2500, 4 = R1.0mV Voltage Bias: 0 = 10 mV, 1 = 3 mV, 2 = 1 mV, 3 = 320 uV, 4 = 100uV, 5 = 32uV, 6 = 10uV Cal Table Units: 0 = LogOhms, 1, Ohms, 2 Volts Sensor Description: 1 to 19 chars, spaces will be eliminated Multiplier: non-zero conddeletecurve Usage: conddeletecurve Syntax : conddeletecurve index | ||||||
Internal Macros: | ||||||
Usage: _cond_send(command) Syntax : _cond_send(command) Internal function to send a command string to the Conductus. This imp. uses gpib at an address defined my the global variable COND_ADDR. Returns CONDREADERROR if the command could not be sent, otherwise CONDOK is returned. _cond_read Usage: _cond_read(command) Syntax : _cond_read(command) Internal function to send a command string to the Conductus and get the reply. _condlistonecurve Usage: _condlistonecurve(crv) Syntax : condlistonecurve(indexnumber) List out the requested curve from the controller. There are 16 possible curves. | ||||||
|