Beamline Instrument Software Support |
|
SPEC Macro documentation:
[ Macro Index |
BCU Home ]
|
k487.mac | ||||||
[ source code | installed at | configured at ] | ||||||
See other macros in category: Detection Multimeter | ||||||
Description:
| ||||||
Documentation:
%PRE% ##################################################################### ######### ########## ######### k487 used as a voltage source using a pseudo ########## ######### motor ########## ######### ########## ######### These macros are intended to talk to a k487 or ########## ######### a k6487 configured in KSCPI gpib labguage ########## ######### ########## ######### To set the KSCPI language: ########## ######### K6487 : ########## ######### + hit "config" key ########## ######### + hit "comm" key ########## ######### + use arriw key up/down in "V-SOURCE" ########## ######### panel untill see "LANG: ...". ########## ######### "LANG" should blink ########## ######### + use left/right arrows below to make ########## ######### the selected language blinking ########## ######### + use the up/down arrows marked "RANGE" ########## ######### to select "SCPI" ########## ######### + hit "ENTER" key ########## ######### ########## ######### ########## ######### ########## ######### ########## ######### ########## ##################################################################### | ||||||
Macros:
Usage: k487add <motor mne> <gpib addr> Adds a k487 pseudo motor. motor mne should already exists in SPEC config | ||||||
Internal Macros: | ||||||
Usage: k487del k487on Usage: k487on k487off Usage: k487off k487_getangles Usage: k487_getangles k487_checkall Usage: k487_checkall k487setrange Usage: k487setrange k487getrange Usage: k487getrange _k487getrange Usage: _k487getrange(motmne) k487_seton Usage: k487_seton k487_setoff Usage: k487_setoff k487setgain Usage: k487setgain k487set_source_current_limit Usage: k487set_source_current_limit k487configreset Usage: k487configreset k487configsave Usage: k487configsave k487configrecall Usage: k487configrecall _k487configaction Usage: _k487configaction(act, addr, loc) | ||||||
|